en
news
news
news

Operation method of ultrasonic atomizer

July 12th at 2:15pm

Add 250ml of cold distilled water to the sink, with a liquid level of about 3cm, and immerse the sound transmitting membrane at the bottom of the atomization tank.  

2. Put the medication into the atomizer and dilute it to 30-50ml. Tighten the lid of the atomizer, place the atomizer into the sink, and cover the sink tightly.

3. Bring all necessary items to the bedside, verify, and explain to the patient to obtain cooperation.  

4. Connect the power supply, first turn on the power switch, the red indicator light will turn on, preheat for 3 minutes, then turn on the atomization switch, the white indicator light will turn on, and at this time, the medicine will be sprayed out in a mist.  

5. Adjust the fog volume as needed (switch from left to right, divided into 3 levels, with 3ml fog volume per minute for high level, 2ml fog volume per minute for medium level, and 1ml fog volume per minute for low level), usually using medium level.  

When the patient inhales, cover the mask over the mouth and nose, and open it when exhaling; Or place the 'mouth in mouth' in the patient's mouth and instruct them to close their lips tightly and take a deep breath.  

7. During use, if the water temperature in the sink exceeds 60 ℃, it can be replaced with cold distilled water, and the machine should be turned off when changing the water.  

If it is found that there is too little liquid in the atomization tank, which affects normal atomization, the dosage should continue to be increased, but it is not necessary to shut down. Just inject it inward from the small hole on the cover. Generally, the usage time is 15-20 minutes each time. After treatment, turn off the nebulization switch first, and then turn off the power switch, otherwise the electronic tube is prone to damage. Organize items, pour out the water from the sink, and dry the sink.